Operating Instructions
WX900 Series
Log Splitter
28
6.11 Log Lifter Shelf
WARNING!
Hands can be pinched, cut, crushed, or severed.
If two or more people load or operate the
machine together, a person can be seriously
injured.
Only one person must load and operate the
machine.
W036
1.
Extend the log lifter shelf arm.
2.
Move the log lifter shelf control lever to the
Lower
position.
Hold the control lever in this position until the shelf is in its
lowest position (on the ground).
3.
Push the log onto the log lifter shelf.
Make sure that the log is safely on the shelf and will not fall
off.
4.
Move the log lifter shelf control lever to the
Lift
position.
Hold the control lever in this position until the shelf is even
with the splitter bed.
5.
Push the log onto the splitter bed.
Figure 17 –
Lower the log lifter shelf
Figure 18 –
Lift the log lifter shelf
6.12 Log Placement
WARNING!
Risk of pinching or crushing hazard between the
wedge or push block and the log!
Never place hands at the ends of the log.
Always grasp logs by the sides when loading or
removing.
W035
• Always grasp the log by the sides not the ends when
placing in or removing logs from the splitter.
This
minimizes the chance of the operator getting fingers, hands
or arm between the wedge / push block and the log.
•
Any logs or debris remaining on the splitter bed should only
be removed after it is safe to do so.
00204
Figure 19 –
Correct log placement
Summary of Contents for WX900 Series
Page 48: ...WallensteinEquipment com...
