wallhugger S-cape 2MR, Operation Manual

S-Cape

™

 2MR Hand Control Operation Guide 99300906

The six step procedure below is required to seperate 2 hand controls from operating 2 beds. One
hand contol per bed operation will result. Before beginning, make certain the beds are plugged into a
working grounded electrical outlet. 

If programming fails, initiate the programming procedure a

second time.

NOTE: OPERATE ONLY ONE (1) HAND CONTROL AT A TIME. OPERATING TWO (2) HAND

CONTROLS AT THE SAME TIME WILL MOMENTARILY BLOCK BOTH RF SIGNALS AND PREVENT BOTH
CONTROLS FROM FUNCTIONING.

S-CAPE

™

 2MR REPROGRAMMING  

separating 2 beds

S T E P   4

The bed will be equipped with either a

power down box

 or 

J box

 (

FIGURE 2

). Locate

the receiver unit for bed 2 and press the 

learn

button

 for 1 second and release.

S T E P   5

On hand control 2, simultaneously press and
hold the 

POS 1 

and the 

head massage on/off

buttons 

(

FIGURE 3

). 

The transmission indicator

light will 

flash slowly

 and then 

flash rapidly

 to

indicate programming mode.

 Continue to hold

for 5 seconds and then release the buttons.

S T E P   6

Repeat Step 4 and Step 5 with hand control 2.

Independent hand control operation is now
restored (hand control 1 operating bed 1; hand
control 2 operating bed 2).

S T E P   2

On hand control 1, simultaneously press and
hold the 

POS 1 

and the

 head massage on/off

buttons

 (

FIGURE 3

). 

The transmission indicator

light will 

flash slowly

 and then 

flash rapidly

 to

indicate programming mode.

 Continue to hold

for 5 seconds and then release the buttons.

S T E P   3

Repeat Step 1 and Step 2 with hand control 1.

Note: wait 90 seconds before proceeding to
Step 4.

STEP 1

The bed will be equipped with either a 

power

down box

 or 

J box

 receiver unit (

FIGURE 2

).

Locate the receiver unit for bed 1 and press the

learn button

 for 1 second and release. 

Note: If

you experience difficulty locating or reaching
the learn button on a J box equipped
adjustable bed, refer to

 J Box Programming

 on

page 5.

POS 1

 BUTTON

TRANSMISSION
INDICATOR LIGHT

FIGURE 3

HEAD MASSAGE

ON/OFF BUTTON

HAND CONTROL 1

BED 1

BED 2

HAND CONTROL 2

J BOX

FIGURE 2: Power down box and J box receiver units.

LEARN
BUTTON

LEARN
BUTTON

POWER
DOWN BOX

POWER DOWN
BOX RECEIVER
UNIT IS NOT
MOUNTED TO
BED FRAME.

J BOX RECEIVER
UNIT IS MOUNTED
TO THE BOTTOM
SIDE OF THE
BED FRAME.

10