19
Ø
Feed
1.7
1.9
Air consumption
180-240 Lt./min. (6.4-8.5 CFM)
180-240 Lt./min. (6.4-8.5 CFM)
Delivery pressure
2.5-3.0 bar (36-43 psi)
2.5-3.0 bar (36-43 psi)
SP version
SP version
MOD.
....................................................................................................................
9010 sp COLLA
...
TECHNICAL SPECIFICATIONS
...
USE
...
ADVICE FOR CORRECT USE
...
ADJUSTMENTS
- Air fitting: G 1/4” M
- Product delivery fitting (version SP): G 1/4” M
- Maximum air pressure: 5 bar (73 psi)
- Maximum product pressure (SP version): 5 bar (73 psi)
- Working pressure: 2.5-3.0- bar (36-43 psi)
- Fan: Fully open
- Air: Fully open
- Product: 3 - 3.5 turns
Spray gun 9010 sp COLLA has been designed for special applications. Particularly indicated for the application of liquid glues.
The instrument is not suitable for applying products that may contain acids or petrol of any kind.
The spray gun can be used in connection with a pressurised tank or a specific pump.
To obtain the best results, the following instructions must be followed carefully:
1.
When possible, use an air pipe with a minimum internal section of ø 8 mm (0.3”).
2.
Make sure the compressed air used is perfectly filtered removing all water, oil or other impurities (for example, by installing
an Asturomec filter regulator ref. 61131 and Asturomec coalescent microfilter ref. 61201, or by the more complete and efficient
WALCOM TD
3
PRO multifunctional filter and heating unit).
1. Set the distance between the spray gun and the surface to be treated between 150 e i 250 mm (5.9-9.8”).
2.
The jet from the spray gun must always be perpendicular to the surface being treated and the product must be applied in
horizontal strokes. Any eventual shift from this position when spraying will result in an uneven application of the product layer.
Summary of Contents for Asturomec 9011 sp HVLP
Page 53: ...53 1 2 ATEX 0 85 A Asturomec 90109 W...
Page 54: ...54 43 C UNI EN 1953 5 4 85 C TMA TMA 90109 W...
Page 66: ...Note...
Page 67: ...Note...
