Chapter 3 Operations Instructions
LOADING OF PLATFORM
Before loading, tilt platform slightly upwards to
compensate for load.
Always load as close to the center of the platform and
as close to the vehicle as possible.
This liftgate is intended for loading and unloading of
cargo only, do not use it for anything but it’s intended
use.
Never transfer loads which exceed rated capacity on or
over platform unless liftgate is equipped with reinforced
platform and platform support bars.
IMPORTANT
!
When platform is tilted up to compensate
for an incline, make certain cargo does not contact rear
sill of vehicle as liftgate is lowered.
GR00709
DRIVE OVER OPTION
If properly equipped, platform may be used as a loading
ramp.
IMPORTANT!
Maximum capacity as a loading ramp includes
combined weight of cargo and cargo carrier.
GR00700
Only use platform as a loading ramp if liftgate is properly
equipped with these support bars and used as directed
on Drive Over Operation Decal.
IMPORTANT
!
Maximum capacity:
5,500 lbs. for aluminum and non-reinforced steel
platforms.
10,000 lbs. for reinforced steel platforms.
GR00493
HILL
HILL
AS PLATFORM IS
LOWERED CARGO
HITS REAR SILL
CARGO
POSIOTIONED TOO
CLOSE TO REAR
SILL
PLATFORM TILTED
UP FOR INCLINE
Support Bars fully
extended
page 13
