Restriction of use of control device
Image 1. Use of radio control device limited by the platform angle.
Sensor
Name
Position
(standard)
Function
Description
Di1
Lift arm
Angle sensor
For autotilt, safety function.
Di2
Platform
Module
Angle sensor
For autotilt, platform angle. There is some trimming allowance
for the bracket in the platform in order to facilitate adjustment of
the platform’s autotilt angle.
Di3
Platform
Module
Angle sensor
Non-actuated Di3 disables Tilt up with the secondary control
device so that the operator must use the two-hand button -
2H along with the primary control device in order to continue
to maintain the tilt up function.
Di4
Tilt cylinder
Open platform
alarm
Pressure sensor for falling pressure connected to +side of tilt
cylinder. In the actuated state, returns the connection signal
(+) to Di4 and results in output signal (-) at Pa-. Also phase
(+) signal out at Pa+. 60 Bar.
Di5
Lift cylinder
Pressure sensor
For autotilt. 1.2 Bar.
Di6
Control card
Jumper
Jumper for deactivation of Autotilt functions in event of up
and down movement.
Cs
Cabin
Activation
No signal in at Cs results in blocked control device terminals.
Signal to Cs usually comes from the cabin switch. In
individual cases where the cabin switch is not used, the (+)
signal comes in to Cs jumpered from (CS PWR) on nearby
terminal.
2H
Control devices
Two-hand but-
ton
Activated in connection with opening and closing of vehicle
body. Used for Quick opening.
Electrical Information
page 31
