Connection unit
Power save mode
If the control card is not used for approx. 5 minutes, it goes into power save mode. Press any
control button for approx. 0.5 seconds to “wake up” the control card again.
Operating information
All the lift’s functions are controlled and monitored through the control card, which is equipped
with an alphanumerical display with a fl ashing light and 2 red LEDS. These display current
operating information. In the event of any operational disturbances, fault codes are displayed to
facilitate troubleshooting.
The display indicates:
- Active control device
- Fault display
- Program confi guration
- Sensors’ current status
The fl ashing light indicates:
- Supply voltage
- Off: No supply voltage
- On: Supply voltage available but CS (cabin switch) is not active.
- Flashing: CS (cabin switch) is active, the system is awaiting input signal.
LED 1 indicates:
- Active input, button(s) on control device pressed.
LED 2 indicates:
- Active output (approved input signal from control device and sensors), the lift is operated.
Image 2. The control card is equipped with an alphanumerical display with a flashing light and 2 red LEDS
Display
Flashing light
LED 2
LED 1
Electrical Information
page 32
