Walter 6265 C, User Manual

8

9

VOLTAGE

Before connecting the tool, make sure that the voltage shown on the rating 

plate is the same as the power source.
Operating the tool on a voltage other than specified on its rating plate, may 

result in personal injury to the user and damage to the unit.

EXTENSION CORD

When an extension cord is required, use one that is sufficient for the power 

requirement of the tool.  Extension cords of inadequate wire size cause a 

serious drop in voltage, loss of power and possible motor damage. To limit 

line voltage drop to a safe level, refer to the following table:

Length in meters

8

15

23

30

Length in feet

25

50

75

100

Wire size AWG

14

14

12

10

NOTE: Extension cords that are used outdoors must be approved for outdoor use.

TECHNICAL DATA   

MODEL 6265 C 

Voltage .........................120 V AC; 60 Hz 

Amperage .....................12 

No-load speed ..............POS.A  POS.B POS.C  POS.D  POS.E  POS.F  POS.G

 .....................................2,000  2,800  3,800  4,700  5,400  6,400  7,300

Spindle Thread .............5/8“ -11 NC   

Weight  .........................2,66kg - 5lb. 14oz 

MODEL 6265 C 

Voltage .........................220 - 240 V AC; 50 - 60 Hz 

Amperage .....................7,2 

No-load speed ..............POS.A  POS.B POS.C  POS.D  POS.E  POS.F  POS.G

 .....................................2,000  2,800  3,800  4,700  5,400  6,400  7,300

Spindle Thread .............M14   

Weight ..........................2,66kg - 5lb. 14oz 

Safety Warnings Specific for Sanding Operations:

a) Do not use excessively oversized sanding disc paper. Follow 

manufacturers recommendations, when selecting sanding paper.

Larger sanding paper extending beyond the sanding pad presents 

a laceration hazard and may cause snagging, tearing of the disc or 

kickback.

Safety Warnings Specific for Polishing Operations:

a) Do not allow any loose portion of the polishing bonnet or its 

attachment strings to spin freely. Tuck away or trim any loose 

attachment strings.

 Loose and spinning attachment strings can 

entangle your fingers or snag on the work piece.

INTRODUCTION

Your WALTER power tool is precision built to meet the highest industrial 

standards. For maximum performance and longest tool life, follow the 

operating instructions and service procedures outlined in this manual.

This tool is 

CSA

 certified.

This tool is double insulated, it does not have to be grounded. 

It may be safely operated from a grounded or ungrounded 

receptacle. It is supplied with a 2-conductor power cord and 

a polarized plug (one blade wider than the other). The plug 

will fit only one way into a polarized outlet. If the plug does 

not fit, have the outlet replaced by a qualified electrician. If an 

extension cord is necessary, only one that is polarized must be 

used. Do not change the plug in any way.

In order to maintain the safety features of the double insulation, the 

housing must not be drilled to affix nameplates or the like.  Self-adhesive 

labels may be used for this purpose.