Maintenance, cleaning, storage and transport
50
EN
For electrodes, tips and other accessories
depending on your applications, please contact
your authorised dealers or order directly from
www.walteronline.com
Repairs should only be carried out by qualified
technicians or by an authorised service centre.
Qualified technicians must have relevant
training and experience, be familiar with the
design and construction requirements of the
product and understand and follow the safety
regulations.
Cleaning
Only use spare parts / accessories from the
manufacturer or authorised and qualified
workshops.
The following original spare parts are available
from the customer service department of the
manufacturer:
• Clean the welder 1 , the welding cable with
electrode holder 11 and the welding cable
with earth clamp 15 only with a damp cloth.
Never use strong and / or abrasive cleaning
agents or solvents. Allow all the parts to dry
completely.
• Make sure that the ventilation slots are open.
• Clean the body regularly with a soft cloth.
• Always keep the welder clean. Dust deposits
can affect the cooling. If you work in a very
dusty environment the welder should be
cleaned monthly with compressed air.
CAUTION!
Make sure that liquids do not get inside
the product.
Storage
• Clean the welder thoroughly before storing
(see chapter "Cleaning").
• Keep the product in a safe, cool, dry and well-
ventilated place in its original packaging, out
of the reach of children when it is not being
used.
• Store the product at an ambient temperature
of 0 - 40° C.
• Lift and carry the device using the provided
handle.
• Wind up the mains cable.
• Secure the welder during transport against
tipping over.
• Use the original packaging and secure the
product against shock and vibrations during
transport.
Transport
Part description
Art. No.
Chipping hammer with wire brush 640337
Automatic welding helmet
39193
Welding shield
640107
Protective glasses
640341
• the ventilation slots are not blocked and
clean. If necessary, use a soft brush to clean
them. If you notice any damage, get it fixed
by a specialist workshop to avoid any risks.
• Ensure that the welding cable, the electrode
holders and the ground clamp are in
good condition. Cables and other current
conducting parts of the welder which are
worn out or damaged are dangerous and can
impair the performance of the machine.
If you notice any damage, get it fixed by a
specialist workshop to avoid any risks.
Summary of Contents for WWS-120B2-K01
