19
18
Listing of Contents
Exploded Drawing
2
Declaration of CE-Conformity
19
Replacement parts
20
1 General
21
1.1
Identification of Model Versions
21
1.2
Normal Use
21
1.3
Improper Use
22
2
Technical Description
22
3
Safety Instructions
23
3.1
Safety Warning Symbols
23
3.2
General Safety Instructions
23
4
Connection of Input Line
24
5
Operational Handling
24
5.1
Safety Instructions
24
5.2
Starting / Stopping Requirements
25
5.3
Spray Pattern Test
25
5.4
Spray Pattern Adjustments
25
5.5
Retooling the Spray Gun
26
5.6
Correction of Spray Pattern Imperfections
27
6
Cleaning and Maintenance
27
6.1
Safety Instructions
27
6.2
Cleaning Complete
28
6.3
Cleaning Routine
29
7
Repairs / Replacements
29
7.1
Replacement of defective Needle Seal Packing
29
7.2
Replacement of Material Control Nozzle and Needle
29
8
Trouble shooting and Corrective Action
30
9
Disposal of Cleaning / Servicing Substances
31
10
Specification Data
31
EC/EU Declaration of Conformity
We, the manufacturers of the equipment, hereby declare under our sole responsibility
that the product(s) described below conform to the essential safety requirements. This
declaration will be rendered invalid if any changes are made to the equipment without
prior consultation with us.
Manufacturer
WALTHER Spritz- und Lackiersysteme GmbH
Kärntner Str. 18 - 30
D - 42327 Wuppertal
Tel.: +49(0)202 / 787 - 0
Fax: +49(0)202 / 787 - 2217
www.walther-pilot.de • e-mail: info@walther-pilot.de
Type Designation
Hand-held Spray Guns PILOT IV / PILOT IV GM
PILOT IV Gravity-Feed Cup
V 11 401
PILOT IV GM Gravity-Feed Cup V 11 441
Intended purpose
Processing of sprayable media
Applied Standards and Directives
EU-Mechanical Engineering Directives 2006/42/EC
2014/34/EU (ATEX Directives)
DIN EN ISO 12100
DIN EN 1953
DIN EN 13463-1
DIN EN 1127-1
DIN EN 13463-5
Specification according 2014/34/EU
Category 2
Part marking
II 2 G c T 6
Tech.File,Ref.:
2403
Authorized with the compilation of the technical file:
Nico Kowalski, WALTHER Spritz- und Lackiersysteme GmbH, Kärntner Str. 18 - 30
D- 42327 Wuppertal
Special remarks :
The named product is intended for installation in other equipment. Commissioning is
prohibited until such time as the end product has been proved to conform to the
provision of the Directives 2006/42/EC.
Wuppertal, the 2nd of November 2016
Name: Torsten Bröker
Position: Manager, Design and Development
This Declaration does not give assurance of properties in the sense of product liability. The safety
instructions provided in the product documentation must be observed at all times.
p.p.
