21
20
Contents
Exploded Drawing
2
Declaration of CE-Conformity
21
Replacement parts
22
1 General
25
1.1
Model identification
25
1.2
Intended use
25
1.3
Inappropriate use
26
2
Safety instructions
26
2.1
Identification of safety instructions
26
2.2
General Safety instructions
26
3
Technical description
27
4
Supply line connection
28
5
Operational Handling
28
6
Spray pattern adjustments
29
6.1
Correcting spray pattern flaws
30
7
Troubleshooting and fault rectification
30
8
Conversion and repair
31
9 Cleaning
32
10
Waste disposal
33
11
Technical Data
33
Declaration of CE-Conformity
We, the manufacturers of the equipment, hereby declare under our sole responsibility that
the product(s) described below conform to the essential safety requirements. This
declaration will be rendered invalid if any changes are made to the equipment without
prior consultation with us.
Manufacturer
WALTHER Spritz- und Lackiersysteme GmbH
Kärntner Str. 18 - 30
D - 42327 Wuppertal
Tel.: +49(0)202 / 787 - 0
Fax: +49(0)202 / 787 - 2217
www.walther-pilot.de • e-mail: info@walther-pilot.de
Type Designation
Manual Spray Guns PILOT Trend
PILOT Trend
Gravity-Feed Cup
V 10 601
PILOT Trend
Material Connection
V 10 602
PILOT Trend-MP Gravity-Feed Cup
V 10 611
PILOT Trend-MP Material Connection
V 10 613
Intended purpose
Processing of sprayable media
Applied Standards and Directives
EU-Mechanical Engineering Directives 2006 / 42 / EC
94 / 9 EC (ATEX Directives)
DIN EN ISO 12100-1
DIN EN ISO 12100-2
DIN EN 1953
EN 1127-1
DIN EN 13463-1
Specification according 94 / 9 / EC
Category 2
Part marking
II 2 G c T 6
Tech.File,Ref.:
2413
Authorized with the compilation of the technical file:
Nico Kowalski, WALTHER Spritz- und Lackiersysteme GmbH, Kärntner Str. 18 - 30
D- 42327 Wuppertal
Special remarks :
The named product is intended for installation in other equipment. Commissioning is
prohibited until such time as the end product has been proved to conform to the
provision of the Directives 2006 / 42 / EC.
Wuppertal, the 1st of December 2014
Name: Torsten Bröker
Position: Manager, Design and Development
This Declaration does not give assurance of properties in the sense of product liability. The safety
instructions provided in the product documentation must be observed at all times.
p.p.
