Cleaning
18
DOK BEMO 11/20 Rev.01 PM
8 Cleaning
This chapter is intended for wallbox operators.
The wallboxes can be cleaned dry or damp depending on the degree of soiling.
8.1 Dry cleaning
f
Before cleaning, remove the plug-in charging cable, or unplug the integral charging cable from
the electric vehicle.
f
Clean the outer surfaces of the wallbox with a clean dry cloth.
8.2 Damp cleaning
If the wallbox is heavily soiled, clean the outer surfaces with a damp cloth.
Approved cleaning agents:
▪
2% soap solution
▪
Dor
®
Universalreiniger
WARNING
Death or risk of injury from electric shock due to contact with live components
f
Before starting damn cleaning, have the wallboxes
disconnected from the mains by a qualified
electrician.
f
Ensure that the supply voltage is switched off.
f
Ensure that power supply cable is electrically dead.
f
Do not open the enclosure during cleaning.
f
Ensure that the covers of the sockets are properly closed.
f
Ensure that no water comes into contact with live parts.
f
Do not use high-pressure cleaners.
CAUTION
Damage to property due to penetration of water and wrong cleaning agents
f
Do not open the enclosure during cleaning.
f
Ensure that the covers of the sockets are properly closed.
f
Ensure that no water comes into contact with live parts.
f
Do not use high-pressure cleaners.
f
Ensure that only approved cleaning agents are used.
f
Before cleaning, disconnect the plug-in charging cable and put on the protective cap.
f
Only clean the outer surfaces using clean water, the approved cleaning agents and a clean, damp cloth.
