8.0 REPLACEMENT OF PARTS
SILOTOP R03
2
FIL.100.--.M.EN Issue: A2
06.12
49
8.3 Replacing solenoid valve
Danger - Warning
Set the filter in safety condition (see glossary and terminology).
1)
Remove coil (
6
) and connector (
7
) after removing the relative ring nut;
2)
Unscrew the component (
5
) ensuring that the pin and spring inside does not fall and that the former slides
perfectly in;
3)
Inspect pin coupling area of components (
4
) to component
(
5
) ensuring there are no impurities;
4)
Remove the hexagonal socket head screws and washers that secure the valve cover (
3
);
5)
Replace the diaphragm (
1
) and the spring (
2
);
6)
Verify that the diaphragm (
1
) is positioned above the drain hole;
7)
Insert the spring (
2
) into the recess of the cover (
3
);
8)
Fit the new cover (if any) by checking that the spring is over the shoulder of the disc diaphragm and the
cover is positioned over the vent hole.
1
•
7
•
2
•
3
•
4
•
5
•
6
•
Jamieson Equipment Company | 5314 Palmero Court | Buford, GA 30518 | 800.875.0280 | sales@jamiesonequipment.com
