SEPCOM
®
Vertical
8.0 REPLACEMENT OF PARTS
2
SEP.SEPCOM_Vertical.--.M.A4.0722.EN Issue: A4
07.22
39
Assembly
Follow the indications bellow:
1)
Wipe the coupling surfaces of the new motor and
gear reducer thoroughly.
2)
Lubricate the shaft (
E
) of the electric motor and the
corresponding seat (
F
) of the gear reducer with the
prescribed lubricant (see “Table of lubricants and
sealants”).
3
) Apply the prescribed sealant (see “Table of lubri-
cants and sealants”) on the coupling surfaces (
G
and
H
).
4)
Fit the motor on the gear reducer.
Important
Do not force the coupling and do not use improper means as this will damage the coupling and the
contact surfaces.
5)
Insert the bolts (
L
) and washers (
M
) in all the bores provided in the connecting flange.
6)
Tighten the screws (
L
).
7)
Make the electrical connection and, on start-up, ensure that the screw rotates in the correct direction (see
“Electrical connection”).
Danger - Warning
Before proceeding with the disassembly and assembly of the motor harness it with suitable hooks
(see picture at the top of the page).
