Wampler METAVERSE, Full User Manual

Page 8

WAMPLER METAVERSE

TAP TEMPO

The Tap Tempo footswitch has two functions - to set the tempo 

by tapping the switch to a rhythm and also as a Preset selector.

SETTING THE TAP TEMPO MODE TO ‘TAP TEMPO’ 
(BLUE LED)

To configure the Tap Tempo Switch to update the delay time (if it 

is currently set to increment the Preset and the Tap Tempo LED is 

Green):
1.  Press and hold the Tap Tempo Switch for 1 second, until the  

  Tap Tempo LED turns Blue and the Preset LEDs sweep left)
The Tap Tempo Switch will now set the delay time according to 

the current Subdivision setting.

SETTING THE TAP TEMPO MODE TO ‘PRESET 
INCREMENT’ (GREEN LED)

To configure the Tap Tempo Switch to increment the Preset (if it 

is currently set to update the delay time and the Tap Tempo LED 

is Blue):
1.  Press and hold the Tap Tempo Switch for 1 second, until the  

  Tap Tempo LED turns Green and the Preset LEDs sweep right)
The Tap Tempo Switch will now increment the Preset and scroll 

through Presets 1-8 and loop back to 1.

PRESETS

The METAVERSE has 128 Preset locations to allow the saving of 

favorite settings (Presets), 8 of which can be saved and quickly 

recalled by the front panel Preset switch or via the Tap Tempo 

Switch in Preset increment mode. 
 

There are 4 LED’s above the Preset switch to indicate which of 

the 8 front panel Presets are active. Presets 1-4 are shown with 

one LED on and three off, Presets 5-8 are three on and one off.

SAVING A PRESET (FRONT PANEL)

To save a Preset to one of the first 8 Preset slots using the front 

panel Preset Switch:
1.  Configure the knobs (and expression pedal settings) as  

 desired

2.  Press and hold the Preset switch for 1 second. The Preset  

  LEDs will blink, indicating the current destination Preset

3.  Optionally press the Preset switch to cycle through the first 8  

  Preset destinations

4.  Press and hold the Preset switch to save the Preset

SAVING A PRESET (MIDI)

To save a Preset to any of the 128 Preset slots using MIDI:
1.  Configure the knobs (and expression pedal settings) as  

 desired 

2.  Press and hold the Preset switch for 1 second. The Preset  

  LEDs will blink, indicating the current destination Preset 

3.  Send a PC message (0-127) via the MIDI Input jack. The  

  current settings will be saved to that Preset location