24
2.9 FITTING THE LOG SET
•
THE CERAMICS VARY DEPENDING ON WHETHER THE FIRE IS SET TO RUN ON NATURAL
GAS OR L.P.G.
•
REFER TO THE PICTURES ON THE NEXT PAGES TO ASSIST CORRECT POSITIONING OF
THE CERAMICS.
•
Take great care when handling the ceramic logs as they are very fragile.
•
Refer to the diagrams when laying the logs.
•
Only use the logs supplied with the fire and
NEVER
use alternatives or extra coals or logs.
•
Incorrect positioning of the ceramics will cause combustion problems within the fire.
2.9A Fitting the Log set- natural gas.
1. Firstly, fill the burner plate with the enclosed vermiculite chips (check fig 4a). A thin level
layer is ideal.
Caution: never use more grains than the supplied amount.
2. Now put the logs in place according to fig. 4b and 4c.
Make sure that when you are putting the logs in place, the pilot flame is not
obstructed by either a log or vermiculite chips.
The logs must be put in exactly as per these instructions. This is in order to ensure that the
flames are impinged as little as possible and thus preventing the disturbance of the flame
pattern and possible sooting.
3. Replace the glass window and make sure that it is firmly shut before you light the fire.
Summary of Contents for BORDEAUX
