20
GB
General
It is common practice for the dealer where you purchased your gas fi replace to take also care of installing it and connecting it
to the gas mains. If this is not the case, please ensure that the installation is done by a certifi ed installer. Connecting gas devices
by unqualifi ed persons is prohibited, in which case we cannot give any guarantee that your gas hearth is functioning properly.
Location of controls and receiver
To access the controls and the receiver, please take the
following steps;
•
grab hold of the side of the lower frame,
•
and carefully pull the frame toward you.
Here, you will fi nd the gas control unit (Mertik GV60-M1
C5D3KL) and the receiver (Mertik GB60-R4AU).
Batteries (standard)
The batteries of the remote handset and the receiver
will last for about one year. We recommend that you use
alkaline batteries.
You need to replace them when the LED of the remote set
becomes dimmer and the word “
BATT
” appears in the display. The receiver will warn you if it’s batteries need to be exchanged.
You’ll hear, during ignition, a beep for 0.8 seconds followed by 0,2 seconds silence.
Replacing the batteries of the remote
Open the lid in the backside cover. Gently remove the 9V block battery and disconnect it from the contact holder. Avoid
pulling the cable. Connect the new battery, replace the set, and close the lid.
Replacing the batteries of the receiver
Carefully pull the entire receiver from the bottom of the stove. Slide open the cover and insert 4 new 1.5V batteries (type LR6
or AA). Please make sure to place the batteries in the receiver in the proper way. Then return the receiver to the stove.
Optional adapter
You can also choose to connect an adapter to the receiver (art. no. INK.3270). When using an adapter, you will no longer need
batteries and will have to remove them from the receiver. In the event of a power outage, you can still use the fi replace by
inserting the batteries.
Setting the remote control handset (standard)
Once the batteries are placed, you need to set the electronic code (only when using it for the fi rst time). Press the reset button
on the receiver until you hear 2 acoustic signs, and then release the reset button. Then press the small fl ame button (2) within
20 seconds until you hear a long acoustic signal to confi rm that the code has been set.
Setting the time
•
Press the big-fl ame button (1) and the small-
fl ame button (2) simultaneously, and the display
will show short fl ashes to indicate that you are in
the set mode.
•
When in the set mode, press the big-fl ame button
(1) to set the hours, and press the small-fl ame
button (2) to set the minutes.
•
Wait or press the
OFF
button (3) to return to
manual control.
GV60-R4AU
Summary of Contents for Larix
Page 71: ......
