20
Newly-built house or recently renovated?
It is advisable to wait six weeks before lighting the hearth in a newly-built house that has recently been
delivered, or a space or room that has recently been drastically renovated. The walls and ceilings still
contain gases, softeners and moist from plasterwork or paint. The warm air-streams may discolour
the dust particles in the space which may stick to walls and ceilings. When the moist in the walls and
ceilings warm up, this may also cause yellowish stains.
Batteries
Your gas hearth is delivered with batteries in the receiver. It is advisable to place new batteries in the receiver
and the remote handset when installing your gas unit. The receiver in the hearth works on 4 batteries of 1.5 V
(type LR6 or AA) or 1 x 9 V alkaline. The remote handset is powered by a 9 V alkaline block battery. The batteries
will last for about one year.
When are the batteries due for replacement?
•
The batteries of the receiver are due for replacement if you see that the engine works with increased dif-
ficulty.
•
The battery of the remote control handset is due for replacement when the display shows BATT in the top
right hand corner.
Replacing the batteries of the receiver
Replacing the batteries in the remote control
Setting the remote control handset
Setting the remote control of your gas unit is simple. Once you have done it you
can operate your hearth in less than no time. Your remote can even pre-set four
time schedules for the desired temperatures.
It is advisable to switch off your hearth when you pre-set the remote to avoid
accidentally changing the temperature of your unit.
If your Stealth hearth has not received a signal from the remote control for two
hours, the unit switches automatically back to the pilot flame setting. The pilot
flame will burn continuously.
If you switch off the pilot light after lighting your hearth, you must wait at
least five minutes before lighting the hearth again.
Setting the time and the date
After placing the batteries, or by pressing the buttons
AUTO
and
TIMER
simultaneously, the display will start flashing. With the
button you select the
hour. With the
button you set the minutes. Wait for a few seconds, or press the
!
!
Summary of Contents for STEALTH - SCHEMATICS
Page 61: ...61...
