WIRING INSTRUCTIONS
Caution!
These instruction are for wiring a
Baldor 2hp motor,
catalogue number
L3515, with a specification number 35J 383 2013, 56/56H frame,
only!
230 volt wiring instructions (high voltage)
The 230 volt switch is for 230 volt applications only!
There is a wiring diagram on the motor connection box. The following is a word
description of this diagram.
1)
The 6’ cord coming out of the switch gets a plug fitting your power supply
connection.
2)
The 3’ cord coming out of the switch goes to the 2hp motor.
a)
Cut back the outer covering on the cord 6”.
b)
Strip off ¾” of insulation of each of the three wires.
c)
Take the cover of the connection box on the motor.
d)
Install the cord connector in the connection box on the motor.
e)
Insert the cord 6” and tighten the connector onto the full cord casing.
f)
Crimp the forked terminal onto the
green
cord wire and place it under the
green
screw
in the motor connection
box and tighten the screw.
g)
Twist together the
white
wire on
the cord to the
blue
#1
wire on
the motor. Twist a yellow wire
nut onto this connection.
h)
Twist the
black
wire on the cord
to the
yellow
#4
wire on the
motor. Twist a yellow wire nut
onto this connection.
i)
The motor connection box wires
brown J
and the
black #5
wires
are joined to themselves with a
yellow wire nut.
j)
The motor connection box wires;
orange #3, red #8, and white #2
are joined to
themselves with a yellow wire nut.
k)
Double check your connections and replace the cover. Install your power plug.
THE 115 VOLT WIRING INSTRUCTIONS ARE ON THE NEXT PAGE.
11
