Installation
17
Step
Description
Image
10
Insert the other end of the tube from the fitting “OUT”
of the Osmo to the T-connection of the water
dispenser and tighten it with the ring nut.
11
Insert one white tube in the T-connection of the
water dispenser and the other end of the tube in the
“water supply inlet” fitting of the sterilizer.
Insert the spiral tube of the water dispenser in the
other free fitting of the T-connection.
Note
:
tighten the tubes connected to the T-connection
with the ring nuts
.
12
Connect the white tube in the fitting “DRAIN” of the
Osmo.
This is a quick-connector fitting: insert the tube until
it hits the back of the fitting and pull slightly to check
it is correctly inserted.
To take the tube out of the fitting, press the fitting
ring with your fingers and pull out the tube.
Note
:
insert the other end of the tube in a draining
sink or a collecting basin.
From fitting “OUT”
To the sterilizer
Spiral tube
