17
Initial start-up
6. Initial start-up
After the SIP Ring Switch has been properly installed and wired, the power supply
can be switched on. All three status LEDs should light up briefly. After approx. 5
seconds only the Power LED should remain on. The Status LED may flash.
If the network connection is working, the green LED in the network socket signals an
active link. The orange LED indicates the network speed:
On = 100MBit/s
Off = 10MBit/s
Assigning the IP address
At delivery, the SIP Ring Switch is set to IP address 0.0.0.0.0 and DHCP is activated.
Networks with DHCP
If a DHCP server is active in the network to which the SIP Ring Switch is connected,
an IP address should be automatically assigned to the SIP Ring Switch. To be able
to specifically access the SIP Ring Switch, you should configure a reservation in
the DHCP server so that the SIP Ring Switch is always accessible under the same
address. The required Ethernet address can be found on the white sticker on the
device.
xxx
(If in doubt ask your network administrator)
Networks without DHCP
Install the WuTility program on a Windows PC (download from
http://www.WuT.de
).
If you do not have a Windows PC, read the subchapter
Alternatives for IP address
assignment
in the appendix.
When WuTility is started, the local subnet is scanned and all detected W&T network
components are listed. Select your SIP Ring Switch and click the
IP address
icon.
