140
W&T
Data transfer per FTP
14.2.2 The automatic FTP client mode
This mode is recommended whenever you need to execute the
same command over and over again. The FTP commands are
configured in the Com-Server. The latter opens a connection to
the FTP server when it receives data at the serial port. It sends
the login and runs the configured file command (getting serial
data and saving as a file or reading a file from the FTP server
and outputting at the serial port). Then the connection is
closed. In the menu branch
SETUP Port x
r
TCP/IP Mode
r
FTP
Client
r
Special Options
the following parameters must be
configured.
n
Auto FTP
Set this switch to
active
to activate the automatic FTP client.
n
FTP Client Login
Enter the FTP commands one after the other:
n
Login
Login name for the FTP server
n
Password:
Login password for the FTP server
n
[TYPE A/TYPE I]
Transmission mode (ASCII/binary)
n
[STOR/APPE/RETR/LIST] [
dir/file
]
File command (see command list at end of sect.)
LIST
Directory
RETR File
APPE
File
STOR File
Close connection
The connection is closed
when the FTP server has
sent all data
The connection is closed
when no serial data have
arrived during the time
period specified under
Inactivity Timeout
or when
the
Protocol Char
was
received.
Open connection
The connection is opened when
any character is received at the
serial port. This character is
not sent.
The connection is opened when
the first character to be sent is
received at the serial port.
Summary of Contents for 58031
