- 25 -
Replacing gearbox oil (Fig 28)
Suggestion engine oil : SAE 80W/90
Oil container
Resolving capacity
：
0.18L
Changing capacity
：
0.16L
Take apart the immiting bolt (2), and the spilling bolt (1).
NOTICE: THE ENGINE MUST BE WARMER
WHEN SPILLING, AND THE VEHCILE MUST
BE STEADY BY MAIN STAND!
•
Reinstall the spilling bolt after clean. And screw up.
•
Inject 100ml to engine through immit bolt
•
Using the injector to immit the oil to the bolt, till full.
•
Install immit bolt and screw up.
Fig28
- 26 -
Spark plug(Fig 29)
The specification of spark plug:
DPR7EA ,DPR6EA (NGK)or D7RTC
•
Take apart the spark plug; Take it of with special tool.
•
Examine if there is dirty on poles and the porcelain
head in center .If it has corroded, must change it .It is
the best way to clean with the liquor of spark plug
Use wire brush if no cleaner
•
Normally the gap between side electrode (1) and
Center electrode (2) is 0.6-0.7.
•
Don
’
t use other spare plug.
Replacing fuse
The specified electric current of the total fuse is 15 A
If the connection is not good, the fuse will overheat and breakdown.
Do not use any fuse whose specification is different from assigned. It is the same
Main reason for wiring burning.
NOTICE: Do not use brass wires to replace the recommended.
(0.6
～
0.7)mm
1
2
Fig29
