- 21 -
Cleaning air filter
（
Fig 20
）
1
Take out rear protecting bar left protecting bar
2
Take apart air filter cover and screw up bolt.
3
Take out filter element
4
Compress air or use dry brush to clean filter element.
•
Do the above opposite to reinstall the air filter.
NOTICE:
Do not use gasoline or low burning
point solvent to clean paper filter element.
Battery maintenance (Fig 21)
It is
adopted
the airtight battery (don
’
t add
water).
Notice: Do not take apart the airtight
battery upper cover
If the motorcycle have not been used for a long time.
Taking off the battery and putting it into a dry place.
The head of battery was corroded, please take
it off and clean. (Can use boil water)
Fig20
Fig21
- 22 -
NOTICE: turn off the ignition switch, take apart negative pole
○
-
first, but install
positive pole
○
+
when you are installing
.
Adjusting idling speed (Fig 22, Fig 23)
warm up few minutes before start
Idle to adjust screw (1) is it is it improve idle
speed slightly to enter to fasten, is it is it
withdraw it than screw slowly after stocking
to fasten to mix and then rapidly, to
stabilizing the position at most, then
withdraw slowly, get and stabilize the
position the most low.
After adjust idle, then adjust accelerate graph handle to free
path for 2-4mm,then use adjustor (2) to adjust, screw down nuts,
and then screw up it after adjust.
Adjusting the good idle speed, when should be able to suddenly
strengthen the throttle, the rotational speed of the engine should be
excessively steady, no flash back and can't go out, stop working or
arrange organ not to blow out at being last throttle.
Fig22
Fig23
