Follow the thick black cable to the
Step ex
Step ex
Step ex
Step extruder
truder
truder
truder MK8+
MK8+
MK8+
MK8+
. Reach in, grasp the Step extruder by its sides, and remove it from the
box. 2.6 Leave it in its protective bag and set it down safely out of the way on your work surface.
Now you can clear away the cardboard inserts and remove the
Accessory Box
Accessory Box
Accessory Box
Accessory Box
from The Duplicator 3. Be careful of the black
plastic
Step ex
Step ex
Step ex
Step extruder
truder
truder
truder MK8+
MK8+
MK8+
MK8+ Mount
Mount
Mount
Mount
.
You should be able to see the build platform: it’s an aluminum plate covered in Kapton tape and attached to the rods by two black
plastic arms. This is where your prints will form.
You’ll need to raise the platform to finish unpacking. You can either turn the threaded screw just behind The Duplicator 3/4logo, or
grasp the build platform firmly on both sides and move it up with gentle pressure.
