11.
You May Now Place the Control
Box Body Aside as it is No Longer
Attached to Any Electronics Except
the LCD.
12.
At this Stage You May Choose to
Remove All Connections from the
Printer and the PSU to the Board. I
Did Not Do this as It May
Inadvertently Damage the Board,
Components or Connections/Wires
and I Do Not Recommend This to
the Average User. However, if you
are comfortable, removing them
does make the next step easier.
13.
Set Up Your Work Area with Proper
Ventilation and Lighting. See Image
for Details.
14.
Using Proper Soldering Technique,
Solder 1 End of the Wire to the
HOTEND Bypass Connection on the
Front of the Board. If Facing the SD
Card Slot, this should be the 2
nd
Green Connection from the Right
and the Right Solder Joint on the
Bypass Terminal.
NOTE:
Be Very
Careful and Use Proper Equipment.
This area is very close to other
components and you may damage
your board or its components by
not taking the proper precautions.
