15.
Find the Connection on the Board
Labeled POWER and Note It
’
s
Position on the Front.
16.
Turn the Board Around so that you
Can See the Solder Joints on the
Back and Identify the Joint that
Corresponds to the GND Label of
the POWER Connection on the
Front.
17.
Using Proper Soldering Technique,
Solder the Other End of the Wire
Here. Follow the Same Precautions
as Step 14.
18.
Here You Can See the Connection
from Both Sides for Reference.
TESTING: ONLY DO THIS IF YOU ARE COMFORTABLE WITH ELECTRONICS.
Before Reassembling the Control Box, You May Choose to Connect the Power Cord and the LCD Screen and Using the
Knob on the Control Box Test that the Printer is Fully Functional. You May Also Pre-Heat to ABS or PLA to Test Whether
Your Connections are Solid.
BEFORE REASSEMBLY, ENSURE THAT ALL CONNECTIONS ARE SEATED PROPERLY.
YOU MAY ALSO CHOOSE TO REMOVE THE RESET JUMPER FROM THE BOARD IF YOU HAVE NOTICED ISSUES WITH
YOUR USB CONNECTION (See Image in Step 19)
19.
Here You Can See the Mezli Board
as It Appears when Returned to the
Control Box. Notice the Wire and
its Placement Relative to the
Control Box.
20.
REASSEMBLE THE BOARD BY FOLLOWING STEPS 2-12 IN REVERSE ORDER. ENSURE THAT ALL CABLES ARE
PROPERLY SEATED AND CONNECTED.
