WAREMA Lamaxa L60, User Instructions

Service

Performing preliminary cleaning

Remove any loose soiling from

the entire product (e. g. dust,

leaves). A whisk broom or

vacuum cleaner can be used for

this.
Do not forget to clear the

opening for the slats.

or

If the product is installed outside

(outdoors), you can also rinse

off loose dirt with clear water at

a low water pressure.
Before you start, remove any

objects that must not get wet.

and (if integrated awning with easyZIP guidance is present)

If the product is installed outside

(outdoors), you can also rinse

off loose dirt with clear water at

a low water pressure.
Before you start, remove any

objects that must not get wet.

Performing detailed cleaning

Cleaner

Prepare a bucket with water

and WAREMA  cleaning agent

for sun shading products.

Note the dosing quantities

specified by the cleaning agent

manufacturer.
Wet the WAREMA  cleaning

glove.

Clean the product components

with a wiping motion. Repeat

the procedure as needed based

on the degree of soiling.
Clean the lateral opening for the

slats on the beams to eliminate

the possibility of malfunctions,

e. g. due to leaves.
Clean the drainage gutters and

drainage pipes to remove any

blockages, e. g. due to leaves.

Remove the detached soiling

before drying.

Cleaning the awning fabric without water (if integrated

awning with easyZIP guidance is present)

In some cases, smaller spots and isolated dirty streaks can
be cleaned without water.

Dab off/strip away soiling with adhesive tape.
and/or
Remove soiling with a non-marking rubber eraser (by

applying light pressure).
Remove soiling with a vacuum cleaner if necessary (on

the low setting).

Cleaning the awning fabric with water (if integrated

awning with easyZIP guidance is present)

Soiling or crusting spread over a large area must only be
removed when wet, in order to keep the dirt from being
rubbed into the fibres and spaces between the fibres.

Add a 5-10% mild washing detergent to lukewarm water

(max. 40 °C). Build up a lather by squeezing out a

sponge several times.
Apply the lather to the soiled locations and let it soak in

for 15-20 minutes.
Wet the awning fabric with clear water at a low water

pressure.
Repeat the procedure as needed based on the degree

of soiling.

Page 24 | 32

2029839 [Rev. 9 - en]/2021-10-11