Service
Drying the product
extend the product into the lower limit position.
Open and close the slats to
allow the water to drip off.
and (if integrated awning with easyZIP guidance is present)
Leave awning fabric that has
become wet to air-dry.
INFO
To prevent scale marks from forming around dried
water droplets, the surfaces of the product can be
rubbed dry using a microfibre or cotton cloth.
Re-impregnating the awning fabric (if integrated awning
with easyZIP guidance is present)
INFO
The cleaning agent and fabric impregnation have
opposing effects. By thoroughly rinsing off the
cleaning agent with clear water, you can preserve
the water-repellent property of the awning fabric for
a longer time.
Every time the fabric is cleaned, the original
protective function of the awning fabric is slightly
diminished. Depending on the fabric type, a
reimpregnation can renew the water-repellent effect
and is therefore recommended.
Only use impregnating agents that are suitable for
fabrics.
Re-impregnation cannot restore the awning fabric to
its original new condition.
Cleaning the drain
INFO
If the drainage gutter is installed without an
inclination, it must be inspected and cleaned more
frequently.
Drainage gutters and drains may clog with leaves,
moss and dirt. This may cause the drainage gutters
to overflow when it rains. If there are trees in the
vicinity, it is better to clean the gutter after all of the
leaves have fallen.
In autumn, leaves may have to be removed more
frequently, depending on the location and position.
Clear leaves and soiling
out of drainage gutters,
the drop tube and the
outlets.
Cleaning the radiant heater (if present)
NOTICE
Product damage from incorrect procedure!
Finger prints on the heating element may shorten
the product service life.
Do not touch the heating element of the radiant
heater with bare hands.
Remove dust from the surfaces using a soft brush or a
feather duster.
Wipe off the heating surface of the Design radiant
heater with the moistened cleaning glove.
Remove the safety grille to clean the reflector on the
Basic radiant heater.
Wipe off the reflector with a soft, lint-free cloth on the
Basic radiant heater.
2029839 [Rev. 9 - en]/2021-10-11
Page 25 | 32
