Maintenance
2021216 [Rev. 2 - en]/2017-04-19
Page 7 | 8
Result of cleaning
NOTICE
Product damage from incorrect cleaning!
Incorrect cleaning procedures may result in
damage to the product or product parts. Surfaces
and structures may be permanently altered (e.g.
scratches).
Do not use high pressure washers, steam
washers, abrasive sponges, abrasive cleansers,
or aggressive cleaning agents or solvents such
as alcohol or naphtha.
Do not use chlorinated cleaning agents on or
near the product.
No claims for damage can be raised on the grounds of this
cleaning information, as the effectiveness depends on a
large number of factors that vary widely from case to case.
The effort required for cleaning and the cleaning results
depend on the degree of soiling. It will difficult or possible
to restore surfaces that have been exposed to the weather
and have not been cleaned over many years to their original
state.
General information on cleaning
Tip/recommendation
The WAREMA cleaning glove combined with
WAREMA cleaning agent concentrate for sun
shading products is ideal for properly cleaning the
surfaces.
The WAREMA cleaning agent can be used for metal
and plastic surfaces and is certified by the GRM
(Gütegemeinschaft Reinigung von Fassaden e.V.)
(certification no. 142, 242, 342, 442, 542).
To order, contact your WAREMA dealer.
For further advise and in technical
matters regarding cleaning,
please contact the Verband
Deutscher Sonnenschutzreiniger e.V.
(www.vds-sonnenschutz.de).
Preparing cleaning
When cleaning the product, protect adjacent areas
against soiling.
Aids required for cleaning:
Soft brush/duster (soft bristles)
Vacuum cleaner (optional)
Bucket
Low-calcium water (recommendation)
Cleaning agent (pH-neutral)
Microfibre cloth or sponge
Cotton cloth
INFO
1 Guide
2 Gauze
3 Handle rail
Performing rough cleaning
Clean the complete product
of loose dirt (e.g. dust). A
soft brush or duster (with soft
bristles) can be used for this.
Alternatively, a moist microfibre
cloth or a moist sponge can be
used.
Performing detailed cleaning
Cleaner
Prepare the bucket with
water and cleaning agent.
Note the dosing quantities
specified by the cleaning agent
manufacturer.
Moisten the microfibre or
sponge.
Clean the product components
with a wiping motion. Repeat
the procedure if necessary due
to the degree of soiling.
Drying the product
INFO
To avoid calcium edges around dried water droplets,
the surfaces of the product can be rubbed dry using
a microfibre cloth or cotten cloth.
Inspecting the product during cleaning
Operate the product and inspect it for visible wear and
damage (visual check).
