890362_b•en•21.03.2011
We reserve the right to carry out improvements
37
7 omfort functions
The comfort functions are for the automatic control of your sun shading
products or other connected products. They can be set separately for each
channel. Experienced users can adjust the control here to suit their particular
preferences.
CAUTION
Changing operator settings may impact the safety of the unit
or reduce its effectiveness! Please consult a specialist if you are not sure
about the effects of a modification.
7.1 Sun control
The sun control is one of the chief comfort functions of the
WAREMA Quatronic dialog, as controlling the sun shading products on the
basis of brightness is a fundamental requirement.
The function works to shade your rooms when the sunlight becomes too
strong and later lets more light in as the sunlight becomes weaker. The
strength of the sunlight is measured by the Quatronic dialog using four photo
sensors that are integrated in the wind sensor.
If the photo reading exceeds the set DOWN limit, the on delay begins run-
ning.
The following display appears:
Brightness display: The upper line shows the brightness in kLux.
Sun
flashes
in the lower line:
Brightness: 18kLx 31kLx 20Lx 50Lx
Status: Cloud Sun Dusk Dawn
When the on delay expires, the sun shading products are lowered.
For the
External venetian blind
or
Roller shutter
setting:
After the DOWN
run time expires, the slats are adjusted to the preselected
slat angle (see
Chapter 8.2 on page 59
)
The display then automatically changes to
Position
and
Cause
:
Position: Lower
Upper Upper
Cause: ManOp Sun Rain ManOp
If the photo reading drops below the UP
limit value, the off delay begins
running.
Brightness display: The upper line shows the brightness in kLux.
Cloud
flash-
es in the status line:
Brightness: 10kLx 18kLx 20Lx 50Lx
Status: Cloud Cloud Dusk Dawn
When the off delay expires, the sun shading products are raised.
omfort functions
Sun control
