890362_b•en•21.03.2011
We reserve the right to carry out improvements
47
7.3.2 The temperature control
triggers a move command
By triggering a direct move command using the temperature control, you can
control your sun shading products according to certain temperatures (inside
or outside) and thus influence the temperature in your rooms.
Under the
InOM
and
OutOM
menu items, you can switch on the direct control
for the respective facade, separately for the inside and outside temperatures.
Subsequently, your sun shading products will move according to the tem-
perature limit values you define.
If the inside or outside temperature exceeds the DOWN limit value, the tem-
perature control triggers a DOWN move command.
The display then changes to
Position
and
Cause
.
Position:
Upper Upper
Cause: Temp Rain Rain Temp
The following display appears after the move command is completed:
Position: Lower Upper Upper Lower
Cause: Temp Rain Rain Temp
If the inside or outside temperature drops below the UP limit value, the tem-
perature control triggers an UP move command.
The display then changes to
Position
and
Cause
.
Position:
Upper Upper
Cause: Temp Rain Rain Temp
The following display appears after the move command is completed:
Position: Upper Upper Upper Upper
Cause: Temp Rain Rain Temp
7.3.3 The temperature control
switches on/off the sun
control
The sun is the most economical heat source we have. It is not always to
your best advantage to block out the sun as soon as the first rays of sunlight
enter the rooms in your building or in your conservatory, and to compensate
this with higher heating costs. Therefore, you can optionally equip your Quat-
ronic dialog with an inside and outside thermometer and use the temperature
control in combination with the sun control.
WARAIAG
With this setup, your sun shading products are not lowered in the
presence of strong sunlight until the desired inside temperature has been
reached.
Under the
InOM
and
OutOM
menu items, you can use the temperature control
to switch on the sun control for the respective facade, separately for the in-
side and outside temperatures. Subsequently, the sun control acts according
to the temperature limit values you define.
omfort functions
Temperature control
