890362_b•en•21.03.2011
We reserve the right to carry out improvements
59
8.2 Run time and turn time
When you lower your sun shading products, there is no need to sit in the
dark. You can, for example, automatically lower the sun shading products
half way or leave only a narrow opening (light band). When using external
venetian blinds, you can set the slats to an angle that will still allow a suf-
ficient amount of light to enter so that you do not need to use artificial light.
These settings are controlled via run times and turn times in the Quatronic
dialog. You can set run times to the nearest second at each facade and also
set any technically possible slat angle via a time entry.
NOTE
The run time of the sun shading product is set to an average value at the fac-
tory. It can be adjusted to the run time of the product actually in use (see the
"Factory settings" chapter in the installation instructions).
8.2.1 hanging the run time and
turn time
The following parameters can be set in the
Runtime
menu:
UP
= Runtime UP (
OFF
,
00:01
to
99:58
',
DURATION
)
DOWN
= Runtime DOWN (
OFF
,
00:01
to
99:58
',
DURATION
)
TurnTime
=
OFF
,
0.1
to
9.9
s,
DURATION
)
TurnMode
= Manual, sun control, manual/sun control, time switch con-
trol, manual/time switch control, sun control/time switch
control, manual/sun control/time switch control, OFF
Keep the
disp/prog
button pressed for approx. 5 seconds.
Wind speed: 8m/s 8m/s 8m/s 8m/s
Time: 10:26:47 Wednesday, 20.11.2008
The selection menu is displayed:
Select the Wind RunT Timer Sun
settings: Rain Temp Product -->
Press the
button above the word
RunT
.
The
Runtime
menu is displayed.
General parameters
Run time and turn time
