2005613_a•en•2017-09-01
We reserve the right to carry out improvements
10
Sensor Splitter
3 Installation
This chapter will tell you where and how the individual components must be
installed.
WARNING
Dangerous situations and malfunctions are possible! The device and its
auEiliary components may only be operated when installed and at the
specified installation locations. Malfunctions or dangerous system states
may occur if this is neglected. In any case, any guarantee or warranty
claim then becomes void.
Follow the points below in the order given:
First determine where the individual components are to be installed. Use the
instructions given in
Chapter 4.1 on page 12
.
Then determine which cables are required to connect the components with
one another. Use the instructions given in
Chapter
.
Lay the required lines. It is advisable to use conduits.
Install and wire the individual components.
Check the wiring before switching on the operating voltage.
Then commission the unit as described in
Chapter 6 on page 25
Check that the connected central control units and sensors are functioning
properly:
WARNING
TElectrical operating equipment must be mounted for easy access.
(VDTE 00100)
