Product information
[B2000171_1] - EN / 20.12.11
Page 4 of 12
Subject to change without notice.
1.4
Important safety information
The safety instructions and warnings described here are
intended to safeguard your health as well as protect the
product. The following points must be
read through care-
fully
.
Damage resulting from inappropriate use or the failure to
observe these instructions or safety information is
not
covered by the guarantee. Liability will
not
be accepted
for secondary damage.
General conditions
Risk of fatal injury from installation error!
Installation in front of emergency exits and
escape doors is
not
permitted.
Operating notes
Risk of crushing injuries!
When raising and lowering the product, do not
reach into movable parts (e.g. between the
drop profile and fabric shaft).
Risk of injury due to static charge!
Contact with persons or objects may result in
electrostatic discharge from statically charged
fabric.
Product damage and property damage
from carelessness during operation!
The projection area of the product must be
kept clear of fixed and movable obstacles.
Product damage from operation of faulty
product!
Only operate the black-out blind if it is in tech-
nically perfect condition. If the black-out blind
makes unusual noises or movements, stop
using it immediately. Inform your qualified
specialist.
2
Product information
2.1
Parts description
dd2
000
00
470
5
1
Box
4 Drop
profile
2
Side cover
5 Fabric
3
Guide rail
Fig. 1:
Parts overview of black-out blind with ZIP guidance
2.2
Technical data/accessories
Details for electric drive
Parameter
Value
Rated torque
8
─
40 Nm
Revolutions (idling)
17 rpm
Mains voltage
230 V AC/50 Hz
Current consumption
0.45
─
1.15 A
Power
100
─
260 W
Degree of protection
IP 44
Safety class
I
Short-term operation (S2)
4 minutes
Limit switch range
64 revolutions
Tab. 1:
Electrical drive data (overview)
