Operation
2008115 [Rev .1 - en]/2016-09-08
Page 5 | 10
3
Operation
INFO
Only operate the product if it is in technically
perfect condition.
Do not operate a product if it is damaged. Always
contact the specialist dealer and protect the
product against being operated as agreed with
the specialist.
3.1
Product with motor
CAUTION
Risk of crushing from failure to exercise care during
operation.
Persons who are located within the projection area
may be injured.
Keep the projection area clear of persons.
Keep children away from the operating elements.
INFO
If the product is not retracted to the upper limit
position for some time and only the slat angle is
changed, the order height may become shorter. This
effect can be eliminated by performing a calibration
(raising and lowering fully).
WAREMA recommends performing a calibration
on the venetian blind at least once a week if the
venetian blind is only tilted.
INFO
Motor with integrated control electronics (type
DCD22-E)
The limit stop of the product is defined in both
directions of movement, i. e. the product is
automatically stopped at this point.
Motor with integrated Hall sensor (type DCD22-
G), external control
The limit stop of the product is defined in the
upward direction of movement, i. e. the product
is automatically stopped at the upper motor limit
position. The lower limit position is not mechanically
defined and must be provided by a suitable
WAREMA control unit. Please contact your qualified
specialist for further information.
Movement
Press the button on the
hand-held transmitter.
The product moves in
the selected direction.
INFO
The product has an upper and lower limit position.
The product automatically stops at this point.
The product can be stopped in any position.
Changing the slat position
Actuate the switch
briefly. The slats tilt in
the selected direction.
Every additional brief acti-
vation of the switch tilts the
slats further. If the switch is
activated for a longer peri-
od, the blind moves in the
selected direction.
Operation using a hand-held transmitter
INFO
Instructions on how to operate the hand-held
transmitter are contained in a separate manual for
the hand-held transmitter.
3.2
Incorrect operation
Accessibility of the operating elements
Never let children play with the operating elements of
the product, such as the hand-held transmitter or switch.
Keep the hand-held transmitter out of reach of children.
