Introduction
2008115 [Rev .1 - en]/2016-09-08
Page 3 | 10
1
Introduction
1.1
Information on safety
It is important to follow these instructions in the interests of
personal safety. Failure to comply with these instructions
when operating the product may result in personal injury
and/or property damage. Failure to comply with these
instructions relieves WAREMA of liability.
Warnings are marked in the instructions with this
symbol or a similar symbol.
Read through the product instructions before
use.
Observe the safety, operating and maintenance
instructions.
Include these instructions if you pass the product
on to a new owner.
Keep the instructions until you dispose of the
product.
1.2
Information on the target group and
application of these instructions
Target group
These instructions are directed at people who operate, care
for and/or maintain the product.
The activities listed in the "Maintenance" chapter are only
permitted to be executed by a qualified specialist.
Contents
These instructions are an integral part of the following
product:
venetian blind with 24-volt electric drive Type 2.25/35.17
inside
The instructions contain important information on the
operation, care and maintenance of this item. They
describe how to operate products with WAREMA standard
drives. Other drives and special solutions are not dealt with.
Permissible activities
Performing tasks on the product that are not described in
these instructions is not permissible. No other alterations,
additions, conversions or maintenance work is to be
carried out on the product other than as described in these
instructions without the written approval of WAREMA.
1.3
Explanation of the signal words
DANGER
Identifies an imminent danger that may result in
death or serious injury.
WARNING
Identifies a potential danger that may result in death
or serious injury.
CAUTION
Identifies a potential danger that may result in light
injury.
NOTICE
Identifies a potential situation that may result in
product or property damage.
1.4
Basic safety instructions
The safety instructions and warnings described here
are intended to safeguard your health and to protect the
product. These instructions must be read carefully and
followed.
Damage resulting from inappropriate use or the failure to
follow these instructions is not covered by the warranty.
Liability will not be accepted for secondary damage.
General operation
The operation of a faulty product may injure persons and/or
damage adjacent parts.
Only operate the product if it is in technically perfect
condition.
If the product makes unusual noises or movements,
stop using it immediately and inform a qualified
specialist.
Possible risk during operation
Incorrect operation can result in personal injury. The
movements of the product can lead to crushing of the limbs.
While the product is moving, do not reach between the
moving parts.
Do not reach into openings on the product while
operating the product.
Monitoring duty during operation
Failure to monitor the product while it is moving may result
in personal injury and property damage.
Keep people and animals out of the projection area.
Remove obstacles from the projection area.
