Product information
[B867213_0] - EN/ 25.09.09
Page 4 of 12
Subject to change without notice.
2
Product information
2.1
Parts description
dd2
000
03
407
1 Fabric
shaft
5 Guide
rail
2 Curtain
6 End
cap
3 Spring-loaded
shaft
7 Cover
panel
4 Console
Fig. 1:
Parts overview of ceiling roller blind
2.2
Technical data/accessories
Electric motor
Parameter
Value
Rated torque
4 - 9 Nm
Revolutions
14 rpm
Mains voltage
230 V AC/50 Hz
Current consumption
0.35 - 0.5 A
Power consumption
65 - 100 W
Motor protection class
IP 44
Short-term operation (S2)
Approx. 4 minutes
Tab. 1:
Electric motor data
Accessories
A wide range of control devices is optionally available for
our sun shading control systems to give you control of the
product.
2.3
Intended use of product
The WAREMA ceiling roller blind is an internal sun
shading system that may only be used as intended (use
as protection against summer light and glare and for
visual privacy of inside areas on vertical, sloped and
horizontal glass surfaces). Inappropriate use may result in
significant danger.
Do not place additional strain, such as that from suspend-
ed objects, on the WAREMA ceiling roller blind as this
may damage the product and is therefore not permitted.
Installation on emergency doors is also not permitted.
WAREMA will not be liable for any resulting damage.
The intended use also includes observing these instruc-
tions and the installation conditions.
2.4
Product identification
The product has a CE mark.
2.5
CE conformity
The product conforms to CE and meets the requirements
of the relevant European guidelines.
CE conformity is certified, and WAREMA holds the
corresponding declaration. To maintain this state and to
ensure that the product can be safely installed and put
into operation, you as the fitter must adhere to the
installation instructions.
Name:
WAREMA Renkhoff SE
Year of declaration of conformity:
2009
Head
office:
Hans-Wilhelm-Renkhoff-Strasse 2
97828 Marktheidenfeld
Germany
Standard
:
DIN EN 60335-2-97
Product:
Roller blind
Intended use:
For inside installation
Noise emission level
1
:
< 70dB (A)
1
In a standard installation of the product on a test stand, the
noise emission level is <70 dB(A). This value may vary de-
pending on the installation.
