2018114_b•en•2019-10-01
We reserve the right to carry out improvements.
6
Button/
display
Cction/result
When you press the control button
,
you can check WHICH target device was
just found.
The product then waves and the control
function LED
flashes
.
RED:
The target device (transmitter
or sensor) can be added to the
network.
Press the STOP button
.
The found target device (transmitter or
sensor) is added to the network.
The target device waves in confirmation.
Briefly press the learn button
to leave
the learn mode.
You can now add additional scanned products in the
same manner.
Briefly press the learn button to leave the
learn mode.
IUTCCE
O
If the large WMS Hand-held transmitter comfort
is still in its factory state (no products have
been learned in yet), the
lights up in red after
the transmitter wakes up.
Step 2:
Copy channel from a WMS Wall-mounted transmitter
basic to a WMS Hand-held transmitter
Button/
display
Cction/result
Press the learn button briefly.
The L LED
lights up green.
Wake up the large WMS Hand-held
transmitter comfort with any product
button.
Select the desired channel on the target
transmitter by pressing and holding the
button of the desired product.
Briefly press the learn button on the TARGET
TRANSMITTER.
The L LED
lights up green.
The transmission LED
on the WMS
Wall-mounted transmitter basic flashes.
GREEN During the transmission of data
from
the
WMS
Wall-mounted
transmitter
to
the
target
transmitter;
this
ends
with
GREEN Lights up continuously for
2
seconds,
transmission
successful
RED
Light up continuously for
2
seconds,
error
during
transmission
The L LED
on the WMS Wall-mounted
transmitter basic goes out.
CExample 5:
Learn the WMS Wall-mounted transmitter basic
into a new receiver (plug receiver, actuator, etc.)
IUTCCE
O
The system can be comfortably commissioned
using our PC software WMS studio pro, a WMS
Central transmitter or the WMS Hand-held
transmitter comfort.
IUTCCE
O
Devices that do not belong to a network yet,
and are not intended to be learned in, must be
de-energised.
Button/
display
Cction/result
Press the learn button on the WMS Wall-
mounted transmitter basic for approx. 5
seconds.
+
The L LED
lights up green; the
transmission LED
flashes. For
several seconds, the WMS Wall-mounted
transmitter basic scans the range for
receivers.
By pressing the learn button again, the
process can be aborted.
The L LED goes out.
If, while scanning, the WMS Wall-mounted
transmitter basic finds a target device
(receiver, transmitter, sensor) that has already
been learned in:
The transmission LED
lights up.
GREEN:
Lights up continuously for 2
seconds
Then scanning continues.
The WMS Wall-mounted transmitter basic
does not find any device during scanning:
The transmission LED
lights up.
ORANGE:
No receiver found.
If the WMS Wall-mounted transmitter basic
finds a receiver, transmitter or sensor that has
not yet been learned in, scanning is stopped.
It is indicated as follows:
The transmission LED
lights up.
RED:
New
receiver
When you press the control button
,
you can check WHICH target device was
just found.
The product then waves and the control
function LED
flashes
.
GREEN: The target device is a receiver
for which the product type can
be adjusted.
By pressing the UP and DOWN arrow buttons,
you can select the desired receiver/product
type:
Press UP
Flashing increases by one
Press DOWN
Flashing decreases by one
