Unit does not start when assembled correctly
• Pull the plug and try plugging into another outlet.
• Press ON ( ) lever to ON.
• Make sure the bowl is properly positioned on the motor base,
that the bowl or chute cover is attached properly, and that the safety
interlock tab on the cover has properly engaged the safety interlock
switch.
Unit stops running during processing
• Select unit may have overheated. Refer to Resetting Thermal
Protection section (page 13).
• Turn unit off ( ) and unplug.
• Remove bowl attachment.
• Remove food being processed from inside the bowl and discard.
• Allow unit to cool for 5 minutes.
• Reassemble unit, and run first with the bowl empty, then put food
into the bowl and try again.
Unit will not come up to full speed
• Bowl is overloaded – remove food being processed and reload
using smaller quantities.
If unit does not operate after you have followed the above
• Check outlet to be sure there is current.
• Check to be sure circuit breaker is on.
• Check to be sure the fuse is not blown, if there are fuses on this circuit.
• Contact your local distributor.
If unit starts to spark or smoke
• Turn unit off, unplug it, and call local factory-authorized service agency.
If food processor makes grinding noise
• Turn unit off, unplug, disassemble, check bowl and blade to see if
they have been rubbing together.
• If bowl and blade are rubbing, call your local distributor.
CLEANING INSTRUCTIONS
Clean the food processor and accessories prior to initial use and
after each use. Do not use harsh, abrasive-type cleaners on any part
of the food processor. Wash the motor shaft with a small brush.
Wash, rinse, sanitize and dry the bowl, covers, small food pusher,
20
