11
OPERATING THE CONTROLS
• Plug the machine into an electrical outlet. The outlet must be
120V, 60Hz.
• There are three control buttons on the base unit.
The three controls are:
ON
OFF
PULSE
How they work:
ON: Press the ON button to start the motor.
OFF: To turn the motor off, press the OFF
button.
To pulse the motor, press the PULSE button
down, then release. The motor will run as
long as you hold the button down; it stops
when you release the button.
HOW TO USE
Continuous use
For continuous processing, use the ON button which is located in
the middle.
Pulsing
• For rapid ON/OFF operation, use the PULSE. The motor runs as
long as you hold the button down; it stops when you release the
button.
• You control pulsing. You control the duration of each pulse by
the amount of time you hold the button down. You control the
frequency of pulses by the rate at which you press the button.
The interval between pulses must be long enough to allow
everything in the work bowl to fall to the bottom.
• Pulsing gives you greater control over consistency when
chopping, blending and mixing.
• Pulsing is also useful in processing hard foods. Pulse the food
a few times to break it up into smaller parts. Then proceed with
continuous use after the pieces are broken up and easier to
process.
Summary of Contents for WFP16S
Page 7: ...7 2 4 1 5 8 7 9 6 5a 5c 5b a b c 10 ...
Page 27: ...27 2 4 1 5 8 7 9 6 5a 5c 5b a b c 10 ...
Page 47: ...47 2 4 1 5 8 7 9 6 5a 5c 5b a b c 10 ...
Page 63: ...63 NOTES NOTAS ...
