4
Features & Benefits
• Hot water dispenser must be plumbed into a water connection.
• Night Mode feature conserves energy and ensures hot water
is ready when you need it.
• Fill rate: approximately 1 gallon per minute when unit is
plumbed-in.
• Initial heat-up time to full capacity: approximately 1.75 hours
(assuming water is at 50°F (10°C) to start)
• Temperature range from 150˚F–205˚F (65˚C –96˚C)
• Hot water dispenser will maintain set water temperature
/- 5°F
• Safety Features (Low and High level sensors)
• Tomlinson
®
No-Drip
®
tap operation*
• Excess water drain: Easily and safely removes excess water
from below spigot level.
• Low water level sensor: In case water level gets low, an
alarm will sound and the heater will automatically be shut off.
This protects your machine. Once the issue is corrected/more
water added, the alarm will stop
• High-level water sensor: If water level gets too high, an alarm
will sound and the heater will automatically be shut off
• Left and right cup-warming guards
• Removable drip tray for easy and convenient cleaning
• Additional fold-down shelf for small cup
GROUNDING INSTRUCTIONS
For your protection, the Waring
™
Commercial Hot Water Dispenser
is equipped with a 3-conductor cord set that has a molded 3-prong
grounding-type plug, and should be used in combination with a
properly connected grounding-type outlet, as shown in Figure 1.
If a grounding-type outlet is not available, an adapter, shown in
Figure 2, may be obtained so that a 2-slot wall outlet can be used
with a 3-prong plug. Referring to Figure 3, the adapter must be
grounded by attaching its grounding lug under the screw of the
outlet cover plate.
* Tomlinson
®
, No-Drip
®
and the Faucet and Handle configurations are registered trademarks of The Meyer Company, Cleveland, Ohio.
Summary of Contents for WWB5G Series
Page 6: ...PARTS 10 9 1 2 4 3 5 6 8 6 ...
Page 18: ...18 PIEZAS 10 9 1 2 4 3 5 6 8 ...
Page 31: ...10 9 1 2 4 3 5 6 8 31 PIÈCES ...
