After the temperature in the stove is lower than 30degree, finally, the phrase
‘GOODBYE’
is displayed
.
!! ATTENTION !!
During the flame switching off phase and exchanger cooling, it isn’t possible to switch on again the
heater up to the operation end; this state is highlighted from the message
‘SWITCHING OFF’
At the switching on the flame isn’t started immediately, depends from the selected functioning
formality. Two formalities are settable: AUTOMATIC or MANUAL, for further details see the
appropriate section.
The switching on Stage, which has the duration of about 15-20 minutes, are necessary to the
resistance to carry the pellets at the switching on temperature, (depends from the heater). The
switching on procedure is showed from a passages set showed in the display. Before starting the
switching on, the heater performs the brazier cleaning and displays the following wording:
Firstly,
Secondly,
Thirdly,
Summary of Contents for 5411074136796
Page 39: ...9 Sch ma lectronique...
Page 50: ...De afstand tussen wand en kachel als deze in het huis is ge nstalleerd MM...
Page 74: ...9 Elektronisch Plan...
Page 112: ...9 Electronic Plan...