11
WARMBOARD COMFORT SYSTEM // ELECTRIC
THERMOSTATS
Warmboard Comfort System offers 3 different types
of thermostats:
f
Heating
Controls the heat in one zone of the house
f
Cooling/Heating
Controls one cooling zone and one heating zone
(limit 2 per Warmsource-E)
f
Floor Warming/Heating
Controls the heat in one bathroom and offers a
warming feature which keeps the floor warm even
when heat is not called for (can be enabled/disabled
by the homeowner)
Thermostat Installation
Every thermostat
MUST
be installed in the location
specified in the WCS Design Drawings. Failure to
do so will cause the system to behave inaccurately.
If there are any discrepancies regarding the
thermostat or zoning, contact us immediately.
f
Remove the appropriate thermostat from the box
f
Grip the ”face“ of the thermostat by the sides with
one hand, and the back of the thermostat with the
other hand, then slowly separate the pieces
f
Set the face of to the side
f
Connect the hot and neutral (black and white) wires
from the back piece to the connections in the junction
box, then fasten into place with the provided screws
– be sure the arrows point “up” (photo)
f
Snap the face plate back into place
f
Repeat for each thermostat, always checking to
make sure they are installed in the correct location
After texture and paint, each thermostat
MUST
be installed in the correct location in order for the
system to perform properly.
