10
warmhaus.com
2.2.13. Installation with Horizontal Flue Sets (Ø60/100 mm)
Connecting Horizontal Hermetic Flue Set to the Combi
Since your combi is a hermetic model, it takes the used air from outside
and discharges exhaust gases created as the result of burning through
the same flue group. In order to prevent emission of excessively harmful
exhaust gases, flue usage and installation is very important, therefore
warnings should be taken into consideration when flue connections are
being performed.
• Make required flue selection for the external flue connection If the
standard flue set is not adequate, please select most suitable elements
from our list of connection accessories considering warnings given in our
user guide.
• Fix the flange under the elbow piece (1) by using the Flange Bolt (5) via
Flange Connection Screws (4) to holes on the combi.
• 2 x Ø60 Sealing Gasket within the hermetic flue set (6) are placed into
internal pipe slots at both ends of the 90° elbow.
• Place the Ø100 Sealing Gasket (12) on the 90° elbow contacting with the
restrictive set.
• Place the External Wall Plate into the flue terminal as seen in Figure
11-12. for grouping the flue output terminal. After placing the flue output
terminal through exterior of wall and the previously made hole, fix the
Internal Wall Plate (11) into the flue terminal. Place, 90° flue elbow of your
combi coupled tightly to the flue output terminal (Figure 12). Then fit the
outer and inner wall flanges (Fig.11_11-12) on the terminal pipe (Fig.12).
Finally, push the Internal Wall Plate to the wall surface and ensure flue
and wall impermeability.
In case the hermetic flue set available in the product package does not
have adequate length, hermetic flue accessories should be ordered from
an authorized Warmhaus dealer according to requirements, non-original
hermetic flue accessories should never be used.
1. 90° Elbow
2. Inspection Cap (Gas)
3. Inspection Cap (Fresh Air)
4. Screws
5. Neoprene Gasket
6. Ø60 Sealing Gasket
7. Ø100 Sealing Gasket
8. Centralizer
9. Interior Flue Pipe
10. External Flue Pipe
11. Internal Wall Plate
12. External Wall Plate
13. Grill
Figure 12
Hermetic combi homocentric flue wall output
Figure 13
Assembled Flue Set
Figure 11
Hermetic combi homocentric flue set.
