15 September 2017
All Dimension are in mm………….Copyright ©
12
Due to continued product improvement, Warmington Ind LTD reserves the right to change product specifications without prior notification.
Nip up screws while holding door in place, then tighten fully with a 5mm allen Key.
No. 6
Ensure that the door is hard back on the hinge side and
tighten the top and bottom nuts while holding the button
head cap screw with the 5mm allen key and spanner.
No. 7
Ensure that the door is parallel to the top of the fire.
Check both ends of the doors to make sure it is parallel to the unit.
No. 8
Ensure that the door seal is mating with the door
frame and making a seal by looking along the door
and seal as they mate. If it is not mating correctly,
repeat adjustment process.
No. 9
Check the seal by opening the door and placing a piece of newspaper
between the door frame and the door seal, close the door and see if
there is some resistance when removing the newspaper. This will
prove if the door is sealed. If seal is not made, repeated the adjust-
ment process or a new door seal rope may be required or repeat the
adjustment process.
