17 October 2014
All Dimension are in mm………….Copyright ©
14
Due to continued product improvement, Warmington Ind LTD reserves the right to change product specifications without prior notification.
Nip up screws while holding door in place, then tighten fully with a 5mm Allen Key.
No : 6
Ensure that the Door is hard back on the Hinge
Side and tighten the top and bottom Nuts while
holding the Button head cap screw with the 5mm
Allen Key and Spanner .
No : 7
Ensure that the Door is parallel to the Top of the Fire.
Check both ends of the doors to make sure it is parallel to the unit.
No : 8
Ensure that the Door Seal is mating with the
Door Frame and making a seal by looking
along the door and seal as they mate. If it is
not mating correctly , repeat adjustment
No : 9
Check the Seal by opening the Door and placing a piece of
Newspaper between the Door Frame and the Door Seal , close
the Door and see if there is some resistance when removing
the Newspaper . This will prove if the Door is Sealed .
If seal is not made, repeated the adjustment process or a new
Door Seal Rope may be required or repeat the Adjustment
process .
