7
www.warmlite.co
INSTRUCTIONS FOR ATTACHING LEGS
TO MAIN UNIT.
1. Turn the product on its side to start
attaching the legs.
2. Place a leg on each corner and use 3
screws for each leg.
3. Tighten the screws clockwise until each
leg is firmly secured.
4. Turn the unit back up to standing position
making sure it is stable.
5. Place the unit in the required location and
plug it in.
CONTROLS
Power Button - Turns the heater
ON/OFF. The heating element will
stop working once the power is
off. The power can be controlled
by pressing the power button on
the control panel or the supplied
remote.
Heat Setting - Use this button
to select between Low (1000W)
and High (2000W) heat settings.
The heat setting button can also
be used to turn off the heat.
Flame Brightness – Adjusts the
brightness of the flame.
Timer - Press this button to select
the length of time you want the
heater to be on. The timing
sequence is as follows:
(0.5h/1.0h/2.0h/3.0h/4.0h/5.0h/6
0h/7.0h/8.0h)
Note:
The maximum time the heater can be on
is 8 hours.
USING YOUR APPLIANCE
1. Plug the heater into the mains socket and
press the button on the rear of the
appliance or on the remote control to turn
it on.
2. On the control panel or remote, press the
button to adjust the brightness of the
flame or to turn it off.
3. Press the button on the remote or on
the heater to toggle between two heat
settings: Low or High.
4. To set the timer, press the timer button on
the control pad or remote control to select
a time between 30 minutes to 8 hours.
Please refer to the timing sequence in the
Controls section.
5. To turn the heater off, press the button
and unplug the heater from the mains
socket.
OVERHEAT SAFETY FEATURE
This heater is equipped with an overheat safety
feature. When the heater’s internal components
reach a certain temperature that could cause
it to overheat and possibly cause a fire, the
heater will automatically shut off.
