9
www.warmlite-products.co.uk
USING YOUR APPLIANCE
Note:
When the appliance is turned on for
the first time or when it has not been used for
some time, it may release a slight, harmless
odour. This odour is a normal occurrence
caused by the initial heating of the internal
heating elements or dust, and will disappear
after a short period of use.
The appliance is operated through the switches
and control dial located at the bottom of the
appliance behind the door.
1. Ensure all switches, and the dial, are set
to the OFF position.
2. Plug the power cord into a mains
power outlet.
3. To power the appliance ON, switch
the power ON/OFF switch to the
ON position ‘I’. The flame effect will
illuminate.
4. When the appliance is not required
switch all the switches to the OFF
position ‘0’ and unplug the appliance
from the power supply.
SELECTING THE HEAT SETTING:
This unit is equipped with a choice of LOW
950W or HIGH 1850W heat settings.
1. Once the appliance is powered ON, select
one of the two heat settings by pressing
the appropriate switch(es):
I - Low heat setting
I and II together - High heat setting
2. To turn the heating function off, switch the
heat setting switch(es) back to the ‘off’
position.
Note:
The LED flame effect operates
independently from the heating function, and
will stay on even after the heat switches have
been set to the ‘OFF’ position.
SELECTING THE TEMPERATURE:
3. Once the heat setting has been activated,
the desired room temperature can be
selected by adjusting the unit’s thermostat
control dial.
4. Rotate the thermostat dial clockwise to
increase or anti clockwise to decrease the
temperature.
5. The thermostat dial must be set at
a higher temperature than the room
temperature before heat begins emitting
from the unit. There will be an audible
click to indicate the heating function has
been activated. The same clicking sound
will indicate the heating function has been
turned off when the temperature dial is
turned down.
Note:
Once the desired ambient temperature is
reached, the appliance will automatically stop
heating. Whenever the ambient temperature
drops more than 2°C below the desired
temperature, the appliance will resume
operation.
SAFETY CUT-OUT:
This appliance is fitted with a safety cut-off
device, which will operate if the appliance
overheats (e.g. due to blocked air vents).
For safety reasons, the appliance will NOT
automatically reset.
To reset the appliance, disconnect the
appliance from the mains supply and allow
the unit to cool down for a minimum of 10
minutes. Check for and clear any blockages.
Reconnect to the mains supply and switch on
the appliance.
CAUTION!
Do not touch the appliance as it
will be hot. Set the appliance switches to OFF
and leave the appliance to cool down fully.
Do not open this product. There are no user-
serviceable parts inside. If the safety cut-off
device continues to switch the appliance off,
seek advice from the manufacturer, its service
agent or a similarly qualified person.
