4
Instructions for Installation
3.1 Instructions for Mounting
EMBER panels must be mounted with the supplied original mounting hardware (aluminum profiles at the back of the
panels and screws included). For panels that are used without the original mounting hardware, the warranty, liability and
consequential damages are void.
EMBER panels must only be used in the manufacturer-related frames.
For panels that are used without the original frame, the warranty, liability and damages are void.
3.1.2. General Instructions for Mounting
Depending on the desired application (see Section 1.3.), different types of installation are provided. All EMBER panels come
with original mounting hardware (aluminum profiles at the backside of the panels and screws for wall/ceiling mounting are
enclosed).
• Make sure that the power plug is not plugged in during assembly. During installation of the unit, also make sure that the
heating panel is not in the “ON” position.
• Do not make any holes in the heating panel. If holes have been made for any reason, do not operate the device. Please
contact the manufacturer or dealer from whom you purchased the product.
• To ensure a quick and easy installation, use the enclosed mounting template and follow the instructions for installation as
described in detail.
• If the device is installed in children’s rooms or rooms accessible to children, make sure that the device is suspended at
least 4 feet above the ground.
• DISTANCE TO BACKSIDE: EMBER panels output convection heat (not infrared radiation) at the backside only. Make sure
that the distance from the wall to the back of the heating panels (metal/aluminum plate) is at least 1 inch in order to
ensure ventilation. This distance is always provided when you use the standard mounting hardware. If you use a different
mounting system than the original, warranty as well as liability for consequential damages is void.
• DISTANCE TO FRONTSIDE: EMBER panels send out infrared radiation only on the front side. Make sure that there is a
minimum distance of 10 inches between the front of the panel and any objects.
• Do not mount the heating panel near a shower, tub or swimming pool. Make sure that the heating panel cannot be
touched by any person who is in the bath or shower. In case of installation in wet rooms, the installation must be done by a
licensed electrician.
• Never mount the heating element before or immediately below a socket.
• Make sure that the plug is accessible after installation of the panels and, if needed, can be immediately pulled.
• If the heating panel is integrated in a permanent electrical installation or connection, a correctly sized circuit breaker is
needed. This connection has to be carried out by a qualified professional.
Section 3
