5
Bracket Assembly Instructions (continued)
Step 3
Measure for bracket positions using the template if desired. At least two brackets must be attached
to a stud.
Step 4
Affix brackets
C and H
to the wall using screw
G
and drywall anchor
F
where necessary.
Repeat Step 4 for the remaining brackets.
Step 5
Place and orient the legs
A and M
with the threaded inserts located at four points on the back of the
towel warmer. Affix legs
(A and M)
to the threaded inserts with bolt
B
and tighten using the large
Allen wrench
i
provided.
Repeat Step 5 for the remaining sections of tubing.
Step 6
Loosen the hex-head screws
D
at the base of each section of legs
A
using the smaller Allen wrench
L
provided. Hang towel warmer by aligning and sliding all four sections of legs
A and M
over
bracket
C and H
. Partially tighten hex-head screws
D
at the base of each section of tubing
A and
M
to hold the towel warmer in place but do NOT fully secure the fasteners at this time. Verify that
bracket
H
is rotated to allow set screw to engage to it.
Hardwired Assembly and wiring
Step 1. Cut power cord as shown.
Step 2. Remove Power Leg.
Step 3. Install plastic plug into Power Leg.
Step 4. Using the template marking made on the wall, drill hole for power cord, and fish power supply
cord out of the wall. Place ¾ size mounting bracket
H
on the wall and make a mark for the
mounting hole.
Step 5. Using an 8mm drill bit, drill hole for the mounting bracket.
Step 6. Insert wall anchor into wall, next to the power cord.
Step 7. Use screw to attach ¾ size mounting bracket.
Step 8. Place collar onto Power Leg and feed power supply cord through the Power Leg.
Step 9. While having assistant hold the towel warmer in place, make power connections. See connection
section in this manual.
Step 10. Push connected wires into Power Leg.
Step 11. Push towel warmer onto all 4 mounting brackets.
Step 12. To fasten the towel warmer to the wall, tighten the 2 set screws on the Power Leg and tighten the
single set screw on the 3 other legs.
Step 13. Have a licensed electrician make connections to the GFCI protected. circuit.
Step 14. Remove plastic shipping caps from vertical bars of towel warmer.
